Mbw MK8 75 Manuel d'utilisateur Page 1

OPERATOR’S SAFETY AND SERVICE MANUALMBW, Inc.250 Hartford Rd • PO Box 440Slinger, WI 53086-0440Phone: (262) 644-5234Fax: (262) 644-5169Email: mbw@mbw

- 7 -3. Remove filler plug, located above sight gage, and filluntil the sight gage is half full. Refer to Fluid levels onpage 6 for type and quantity

- 8 -SERVICEAssembly and disassembly should be performed by aservice technician who has been factory trained on MBWequipment. The unit should be clea

- 9 -MBW, Inc.250 Hartford Rd • PO Box 440Slinger, WI 53086-0440Phone: (262) 644-5234Fax: (262) 644-5169Email: [email protected]: www.mbw.comMBW (UK

- 10 -Main Assembly

- 11 -Control Assembly

- 12 -Drive Assembly

- 13 -Right Blade and Gearbox Assembly

- 14 -Left Blade and Gearbox Assembly

- 15 -Engine Assembly

- 16 -0878LIFTING HANDLE18064LIFTING SLINGAccessories

TABLE OF CONTENTSSafety Information . . . . . . . . . . . . . . . . . . . . . . 1Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . .

- 17 -NOTES

- 18 -MBW, Inc.250 Hartford Rd • PO Box 440Slinger, WI 53086-0440Phone: (262) 644-5234Fax: (262) 644-5169Email: [email protected]: www.mbw.comMBW (U

CALIFORNIA PROPOSITION 65 WARNINGEngine exhaust and some of its constituents are known in the state of California to cause cancer, birth defects, and

- 1 -SAFETY INFORMATIONIntroductionThis Safety Alert Symbol is used to call attentionto items or operations which may be dangerousto those operating o

- 2 -Safety Decals (Decal Set #18007)09867ENGINEOIL DRAIN1800612573WARNINGROTATING PARTS can crush and cut.Keep hands away!13483CAUTIONWear approved h

- 3 -SPECIFICATIONSMK8 75Dimensions 61 x 30.7 x 41in. (1550x780x970mm)Weight 374.8lbs. (170kg)Motor Honda 13HPMax Engine RPM 3600 RPMMin / Max Blade R

- 4 -OPERATIONIntroductionMBW equipment is intended for use in very severeapplications. They are powered by four cycle engines andare available in dif

- 5 -subsequent smoothing operations continue increasing theblade inclination until obtaining the desired finish.Stopping Engine1. Move throttle to id

- 6 -MAINTENANCEWARNINGAlways follow the stopping procedure beforeservicing or lubricating the unit.After servicing the unit, replace and fasten allgu